TD 92675EN
9 December 2011/ Ver. D
Configuration Manual
Ascom i62 VoWiFi Handset
12
17
Select “Network
X
“ (
X
represents A, B, C, or D).
18
In the
Security mode
drop-down list, select “EAP-TLS“.
19
In the
EAP client certificate
drop-down list, select the client certificate to be used.
Click “OK“.
20
Remove the VoWiFi Handset when synchronisation is finished.
Repeat the steps 11-13, 20 (if needed, perform the steps 14-19) for all VoWiFi Handsets.
4.3
Installation using the Handset’s Admin Menu
It is possible to install a VoWiFi Handset using its Admin menu. This is useful when no PDM/
IMS3 is available and the VoWiFi Handset needs to be installed quickly.
Note:
It is only possible to configure the basic settings via the Admin menu.
1
There are two options to access the Admin menu:
•
If the VoWiFi Handset has been factory reset or not been configured; in idle mode,
enter 40022.
•
If the VoWiFi Handset has been configured; press “Menu“, select “Settings“ and
enter 40022.
Once the Admin menu is accessed it is reachable from the menu "Calls".
2
Set the following parameters:
•
Network settings
1
(located under Network setup)
•
VoIP settings
2
(located under VoIP)
•
Unite settings
3
(if any) (located under Unite)
•
Syslog settings
4
(if any) (located under Syslog)
4.4
Configure a Handset with a Template
It is possible to select a VoWiFi Handset in the PDM and directly change one or more
configuration parameters. By using a template, the same configuration can easily be applied
to many VoWiFi Handsets simultaneously. Templates are also an efficient way to give good
control over which changes that are applied to each VoWiFi Handset.
Templates enables configuration of all aspects of a VoWiFi Handset from sound volume to
keypad shortcuts.
Your supplier can provide example templates for different PBX:s. The VoWiFi Handset will
have full functionality towards the PBX even without such a template. By using such a
template, though, the VoWiFi Handset will be customized for that PBX with menu options
for PBX specific functions.
4.4.1
Create a template
1
Open the PDM or the Device Manager in the IMS3.
2
Select the
Templates
tab and open the menu “Template > New...“. The
New Template
window is opened.
3
Select the device type and parameter version that matches the software version
installed on the VoWiFi Handset. Give the template a descriptive name.
1.
All required system settings for the WLAN. For example SSID and Security mode
2.
VoIP protocol, Gatekeeper IP address or SIP proxy IP address used to access the PBX.
3.
IP address and password (if any) to the IMS3.
4.
The parameter “Syslog“ must be enabled in order to set the “Syslog IP address“.