TD 92675EN
9 December 2011/ Ver. D
Configuration Manual
Ascom i62 VoWiFi Handset
16
Apply Template to a Handset without a Number
1
Put the VoWiFi Handset in the DP1 cradle.
2
In the
Found Device Wizard
window, select the “Run template“ option.
3
Click “Next >“.
Only templates with a parameter version matching the selected VoWiFi Handset will be
shown.
4
Select the template that shall be applied and click “OK“.
The template is applied. The number of parameters in the template will affect the time it
takes to apply the template to the selected VoWiFi Handset.
5
Switch off the VoWiFi Handset when User name and Password are displayed.
Tip:
If the VoWiFi Handset shall replace a broken VoWiFi Handset, continue with
5.2.2
Replacement of Handset with IMS3
on page 21.
5.1.2
Upgrade Handset Software
Note:
Pay attention to the software Release Notes before changing the software.
The software in the VoWiFi VoWiFi Handset can be upgraded either Over the Air (OTA) via
the TFTP, the PDM by USB cable, or OTA via Centralised Device Management (IMS3).
5.1.3
Upgrade Software OTA via TFTP
Software upgrade OTA via TFTP is used in small VoWifi systems and is recommended to use
if no IMS3 is available. The benefit is that the VoWiFi Handsets do not need to be collected
by the administrator since the software upgrade is peformed over the air.
In order to upgrade the software via TFTP, the following must be done:
1
If needed, the VoWiFi Handset must be configured in PDM to access a TFTP server, see
Configure Access to the TFTP Server
.
Tip: It is recommended to configure the TFTP server’s IP address when installing the
VoWiFi Handsets. See
4.2 Installation without Central Device Management (IMS3)
on
page 11.
2
If needed, a new software information file (packageinfo.inf) and a software (.bin) file
must be uploaded to the TFTP server. These files are provided by your supplier. See
the manual for the TFTP server used for more information on how to upload files.
3
The VoWiFi Handset must be restarted. When the VoWiFi Handset has been
restarted, it connects to the TFTP server and downloads the software information file
(.inf) that contains information about the software version. If the software version
differs from the VoWiFi Handset’s software version, the VoWiFi Handset will
download the software file (.bin) from the TFTP server. The VoWiFi Handset will be
restarted when the software upgrade is performed.
Configure Access to the TFTP Server
1
Put the VoWiFi Handset in the DP1 cradle.
2
Open the PDM.
3
Open the Numbers tab and select the VoWiFi Handset.
4
Make a right-click and click “Edit parameters“.
5
Select Device > General.