TD 92675EN
9 December 2011/ Ver. D
Configuration Manual
Ascom i62 VoWiFi Handset
30
6.3.3
World Mode Regulatory Domain
There is a set of regional rules for the world mode settings and the a-band that the VoWiFi
Handset complies to. The preferred and the default setting is “World mode (802.11d)”. The
VoWiFi Handset gets its regulatory settings from the AP. If this is not supported by the AP,
then this has to be set in the VoWiFi Handset as follows:
1
Select Network > Network A (B, C, or D).
2
In the
World mode regulatory domain
drop-down list, select one of the following:
•
World mode (802.11d) (default)
•
ETSI
•
Japan
•
USA
6.3.4
Radio and Channel Selection
The VoWiFi Handset supports the 802.11a/n radio and 802.11b/g/n radio, but it cannot
use the 802.11a/n radio and the 802.11b/g/n radio simultaneously. The radio determines
which channels that can be used.
802.11 a/n Channels
Defines which 802.11a/n channels to use. It is recommended to use the value “UNII-1“.
Select “Advanced“ only if the channels shall be set in the
Advanced: 802.11 channels
parameter, see
Advanced: 802.11 Channels
on page 31.
1
Select Network > Network A (B, C, or D).
2
In the
802.11 protocol
drop-down list, select “802.11a/n“.
3
In the
802.11a/n channels
drop-down list, select one of the following:
Note:
The selected World Mode Regulatory Domain determines which channels to be
used. See
Bands and Channels used by WiFi a-radio
.
•
All
•
Non DFS
•
UNII-1
•
UNII-3
•
UNII-1, UNII-2
•
UNII-1, UNII-2, UNII-3
•
UNII-1, UNII-2, UNII-2 Extended
•
Advanced