TD 92675EN
9 December 2011/ Ver. D
Configuration Manual
Ascom i62 VoWiFi Handset
45
In
figure 6
, a message with prio 2 is received and displayed in the VoWiFi Handset, TTP and
TTR for the message is started.
After 10 seconds, a second message with priority 1 is received and displayed while the
message with priority 2 is put in the queue. TTP for the message with priority 2 is paused,
but TTR continues. TTP and TTR for the message with priority 1 is started.
After 20 seconds, TTP expires but TTR continues for the message with prio 1 and the
message is placed in the queue. The message with priority 2 is shown again and its TTP
continues.
TTP expires after 10 seconds but TTR continues for the message with priority 2. In this case,
all messages have been shown 20 seconds each, and the oldest shown message with the
highest priority is displayed (in this case, the message with priority 1). The VoWiFi Handset
does not indicate when it shows the message again, since it already has been shown and
indicated once. The message with priority 2 is placed in the queue.
After 80 seconds, the TTR expires for the message with priority 2, and it is removed from
the queue and is indicated as an unread message in the Messaging Inbox. When TTR expires
for the message with priority 1, it is also indicated as an unread message in the Messaging
Inbox.
Note:
If no messages have been read/closed manually and TTP expired for each message, a
dialogue window
New messages(s): [number of messages]. View now?
is displayed. All
messages are indicated as unread messages in the Messaging Inbox.
Example 4
This example describes the message handling with the following message settings:
•
TTP= No prioritization
•
TTR= Close manually
Tip:
It is recommended to use this settings if messages regardless of priority shall be read in
chronological order, that is, the newest message shall be displayed first.
Figure 7. Display messages in
chronological
order regardless of priority
In
figure 7
, a message with priority 1 is received at 13:59. Another message with priority 2
is received at 14:02 and will be displayed. The message with priority 1 is put in the message
queue. The user needs to close the current message (priority 2) to show the message
(priority 1) in the queue. When closing the message (priority 2) it will be indicated as a read
message in the Messaging Inbox.
Figure 7.
The user closes
the message
Prio 2
14:02
New messages
Prio 1
13:59
Prio 1
13:59
Prio 2
14:02
Messaging Inbox
Prio 2
14:02
Prio 1
13:59
Prio 1
13:59