TD 92675EN
9 December 2011/ Ver. D
Configuration Manual
Ascom i62 VoWiFi Handset
55
gives a more accurate location using a third-party Real-Time Location System (RTLS)
solution.
The following RTLS solutions are supported:
•
Cisco RTLS Solution
In order to use the Cisco RTLS solution, a Cisco Mobility Services Engine must be used and
configurations in the VoWiFi Handset are required.
•
Ekahau RTLS Solution
In order to use the Ekahau RTLS solution, the VoWiFi Handset must have the
Ekahau
license (see
5.1.7 Upgrade Handset Functionality using License
on page 17) and also be
configured.
Additionally information about AP location and RTLS location, see
Function Description,
Location in Ascom VoWiFi System
,
TD 92607GB
.
6.15.1 Configure Handset for Cisco/Ekahau RTLS Solution
1
Select Location > Common.
2
In the
Location scanning drop-down list, select “Enable“
.
3
In the
Scanning interval
1
field, set the time between the scanning periods.
4
In the
Scans per scanning period
1
drop-down list, select how many scans that should
be performed during each scanning period.
If the Ekahau RTLS solution is used, also perform the steps 5 - 8.
5
Select Location > Ekahau.
6
In the
EKAHAU license
drop-down list, select “Yes“. Additional parameters are shown.
7
In the
IP address
field, enter the IP address to the Ekahau location appliance.
8
In the
Listening port
field, enter the port the location appliance is listening to.
1.
Note that close scanning periods, and frequently scans per period, will shorten the battery time.