2000 01 25 /Rev.A
7
User Manual
Transceiver U922
TD 91836GB
Charging the Battery
Beep signals and the icon indicate a low battery warning. The unit should
then be charged as soon as possible. Beep signals and the icon indicate low
battery. The unit should then be charged immediately. At low battery, it is not
possible to start a speech call - only to receive speech. However, the alarm func-
tions are not affected.
When placed in a desktop charger, the LED on the U922 flashes until the battery is
fully charged. A red LED on the charger indicates a fully charged battery.
In a charging rack, the LED on the U922 flashes until the battery is fully charged. A
steady LED on the U922 indicates a fully charged battery. Keep the unit in the
charger when not in use.
Changing Beep Volume
Press OK to enter the main menu. Press the Step-key until “Set?” is displayed and
then press OK until “Vol” appears. Press and hold OK until the required signal is
reached. The “ ” symbol indicates a gradually increasing volume. “Vol 0 + Vib”
indicates vibrator without beep signal. “Vol 1 + Vib” indicates vibrator and beep
volume level one.
Activating Time Stamp
At the end of each message, the time stamp shows the time when the message
was received, . Press OK to enter the main menu, then press the Step-key until
“Set” is displayed. Press OK and step to “Time Stamp”. Press OK to toggle be-
tween On/Off.
Activating Reminder Beep
The reminder beep sounds every five minutes until the message is accepted. Press
OK to enter the main menu, then press the Step-key until “Set?” is displayed. Press
OK and step until “Remind Beep” is displayed. Press OK to toggle between On/Off.
Enabling Group Number
To enable/disable pagings to group numbers, press OK to enter the main menu.
Press the Step-key until “Set? is displayed and press OK. Press the Step-key to
display the group numbers, the group numbers are displayed after your call
number. Press OK to toggle between On/Off. On indicates that the number is
enabled.
Activating Manual Absence
Press and hold the preprogrammed key until “Absence” is displayed. Press OK to
switch between On/Off.
Activating Hot-key
Press and hold the preprogrammed key until the call number appears and is
transmitted.
Special Codes
If the function of the OK button is set to "Send", it is possible to send commands
to the system to perform an activity, for example to open a door. This is done by
sending special codes. The codes are supplied by the system administrator. Enter
the preprogrammed code. When “Send” is displayed, press OK.
Summary of Contents for U922
Page 22: ...User Manual Transceiver U922 ...
