Ascon Tecnologic - e30V - OPERATING INSTRUCTIONS - PAG. 5
6. ACCESSORIES
The instrument is equipped with a 5-pole connector which
can be used to link some external accessories that allow to
perform some functions in “off-line” mode.
6.1
Parameters configuration by “A01”
The A01 device an be linked to the 5 poles connector to trans-
fer from and toward the instrument the functioning parameters.
This device it is mainly usable for the serial programming of
some instruments which need to have the same parameters
configuration or to keep a copy of the parameters setting of an
instrument and allow its rapid retransmission.
The same device allows to connect a PC via USB with which,
through the appropriate configuration software for “AT Univer-
salConf tools”, the operating parameters can be configured.
To use the A01 device with the e30V instrument, the A01 must
be correctly supplied.
AC supply
Supply adapter
12 VDC
Ente
r
PW
S
12
V
A B C
TTL
+
-
US
B
to PC
USB
For additional info, please have a look at the “
A01 instruc-
tion manual
”.
7. PROGRAMMABLE PARAMETERS TABLE
Here below is a description of all the parameters available
on the instrument. Some of them may not be present, either
due to the fact they depend on the type of instrument or be-
cause they are automatically disabled as unnecessary.
Parameter
Description
Range
Def. Note
1
iuP
Unit of measurement and
resolution (decimal point)
C0
°C, resolution 1°;
F0
°F, resolution 1°;
C1
°C, resolution 0.1°;
F1
°F, resolution 0.1°.
C1
2
iFt
Measurement filter
oF ÷ 20.0 s
2.0
3
iC1
Pr1 Probe Calibration
-30.0 ÷ +30.0°C/°F
0.0
4
AHA
High temperature Alarm
threshold
oF
Disabled;
-99.9 ÷ +999°C/°F.
oF
5
ALA
Low temperature Alarm
threshold
oF
Disabled;
-99.9 ÷ +999°C/°F
oF
6
AAd
Temperature Alarms
Differential
0.0 ÷ 30.0°C/°F
1.0
7
AAt
Temperature Alarms Delay
oF
Disabled;
0.01 ÷ 9.59 (min.s ) ÷ 99.5 (min.s x 10). oF
8
tPP
Password to Access
Parameter functions
oF
Disabled;
001 ÷ 999.
oF
