Ascotel® IntelliGate® 2025/2045/2065 as of I7.9
180
Configuration
sy
d-
020
4/1.
7
– I7.
9
– 1
2
.2009
The licences must be activated. The licence code can be edited both online and of-
fline with AIMS:
1.
Type in the licence code under 1_2_2 "
Licensing
" in the system configuration.
The licence code is stored in the EIM.
2.
Upload the system configuration data and restart the system; the licensed func-
tion(s) is(are) now enabled.
All the features (even those subject to charges) can be configured offline without a
valid licence number. When the configuration data is uploaded, AIMS will warn the
user that the system does not yet have the required licences.
Each licence code can only be used for one PBX. To licence several systems, you will
obtain separate licence codes to match the licence information of the individual
systems.
The licence information can be viewed directly from the PBX using the Configura-
tion Manager in AIMS.
The data stored on the EIM card is not deleted by a first start of the PBX, and re-
mains available.
As of I7.6 the OIP licences are no longer managed in the PBX, but by the OIP itself.
See also:
"Licence-related system limits", page 44
5. 6. 5
Reading initialization values
There is a simple method for reading out the first-start values:
1.
Create a new system on the AIMS Shell in offline mode
2.
Log in with the first-start access data
3.
Open Configuration Manager
4.
Add the desired hardware in the "
System configuration
".
5.
Add system terminals, mailboxes, direct dialling numbers etc.
6.
Most first-start values can now be read out.
