Ascotel® IntelliGate® 2025/2045/2065 as of I7.9
188
Operation and Maintenance
sy
d-
020
4/1.
7
– I7.
9
– 1
2
.2009
It is possible that there is insufficient storage space in Flash memory for the update
of the PBX software. In this case the wave files (Voice Mail, Courtesy and Music on
hold) can be stored on the PC and deleted from Flash memory. When the monitor-
ing phase is finished, the wave files can be reloaded to the PBX (see
).
If for whatever reasons the software upload is not possible or if a fault occurs dur-
ing the upload, the previous system software with the previous configuration data
remains activated.
If errors are detected in the system software during the time in which the newly
loaded system software is being monitored for fault-free operation, the previous
system software is reactivated.
If the previous software is no longer available, an Emergency Upload has to be initi-
ated using the AIMS Upload Manager. An triggered Emergency Upload is signalled
by "EUL" on the 7-segment display (see
"Emergency Upload of the system soft-
).
Successful and failed software uploads are stored as event messages in the PBX
and output at the set signal destinations.
See also:
For information on event messages and signal destinations, see
Initiating an upload process
To ensure a successful software upload, carry out the following preparatory steps:
1.
Recommendation: Use AIMS to save the configuration data (
Tools
→
Backup
).
2.
If necessary: Save the wave files (Voice Mail, Courtesy and Music on hold) (
Tools
→
Partial download
→
Download wave files
).
3.
Call up the AIMS Upload Manager.
4.
Select the "
Configuration
" tab.
5.
Enter user name and password (changed) of a user account.
Note: To perform the upload, the user account must be assigned an authoriza-
tion profile for which the "
FTP
" interface access is enabled (see
6.
Select the system type.
