Ascotel® IntelliGate® 2025/2045/2065 as of I7.9
88
Installation
sy
d-
020
4/1.
7
– I7.
9
– 1
2
.2009
Note:
The ”Direct connection” variant with socket clamps is not suitable for
shunting..
Disconnecting the connecting wires
Fig. 37
Disconnecting the connecting wires
Use a size 1 screwdriver to loosen the connecting wires.
1.
Insert the screwdriver into the rectangular aperture.
2.
Press the screwdriver down until the wire clamp opens, and pull out the con-
necting wire.
Note:
Direct connection is also possible using stranded copper conductors
(litz wires), conductor diameter 0.4 to 0.8 mm, and the corresponding
commercial clamps (e.g. Messrs. Riacon; type 166; contact spacing
3.5 mm; 2-pin Order No. 311661 02, 4-pin Order No. 311661 04 or 8-pin
Order No. 311661 08). Ensure sufficient strain relief!
4. 6. 2
Indirect connection
There are two possibilities for connecting the system indirectly to the telephone
network and terminal-side cabling:
•
Connection via main distribution board
•
Connection to a universal building cable installation (UBC)
1
2
3
4
haz1
113aadea0