Ascotel® IntelliGate® 2025/2045/2065 as of I7.9
200
Operation and Maintenance
sy
d-
020
4/1.
7
– I7.
9
– 1
2
.2009
The following data is deleted:
•
The system and terminal configuration data of the terminals on the terminalin-
terfaces that are no longer present in the new configuration.
•
The system configuration data of the network interfaces that are no longer
present in the new configuration.
Tab. 102 Example: Reducing terminal interfaces
Note:
If the terminal configuration data of system terminals is deleted following
the reconfiguration of an expansion card, a warning message will appear
beforehand to give you the possibility of cancelling the process. However,
this is possible only if the configuration data of the original card was not
already deleted beforehand.
New card with more ports
A card is replaced by a similar card with more ports.
Procedure:
1.
Change the card and put the PBX into operation again (see
tive expansion card", page 199
).
2.
Select ”Confirm System Configuration” in the AIMS Configuration Manager.
3.
Configure new ports.
The system configuration data (User No., User configuration, etc.) of the terminals
on the new ports is created as new data (initialization values).
Tab. 103 Example: Expanding the number of terminal or network interfaces
Change slot
Expansion cards can be moved to a different slot. The terminal configuration data
of the system terminals can be transferred.
SC-16AD2
→
SC-08AD2
The configuration data of terminal interfaces 9...16 is deleted.
SC-08AD2
→
ISDN-04ST
The configuration data of all 8 terminal interfaces is deleted.
SC-08AD2
→
SC-16AD2
The configuration data of terminal interfaces 9...16 is created as new data.
ISDN-04ST
→
SC-08AD2
The configuration data of all 8 terminal interfaces is created as new data.
