Ascotel® IntelliGate® 2025/2045/2065 as of I7.9
Operation and Maintenance
235
sy
d-
020
4/1.
7
– I7.
9
– 1
2
.2009
•
Required output format "
PC
" or "
Printer
" (see
•
With "
Printer
" output format: Language in which the event messages are to be
output.
•
With the V.24 interface of the mainboard - port number
•
With the V.24 interface on the PA - port address
•
With "
PC
" and “
Printer
” output format as the output location: Maximum page
length of the printout
Output formats
There are two output formats available for local signal destinations connected to a
V.24 interface.
•
Printer Format
•
PC format
Printer Format
Fig. 104
Event signal format "
Printer
" for printer as the local output destination (example with date,
time and event message)
PC format
The event signal format "
PC
" is required if a PC is configured as the local signal des-
tination using the System Event Manager (SEM).
Configuring a local signal destination on an S interface / ISDN
As with an external signal destination the event message opens a PPP communica-
tion channel from the PBX to a Terminal Adapter, connected either directly to a PC
with the System Event Manager (SEM) or indirectly via a LAN (ISDN gateway). Once
the event has been confirmed, the PBX clears down the PPP connection.
Configuring a local signal destination on an S interface
The event messages are displayed in PC format.
The "
Local Output Interface
" must be set on "
IP Destination
" in the Fault & Mainte-
nance Manager.
11.03.97 10:12 LOSS OF SYNC ON T/T2 O.9
haz1234aaena0
11.03.97 10:12 LOSS OF SYNC ON T/T2 O.9
haz1234aaena0
