20311855en_ba_a0
13
English
Programming your telephone
Points to remember when programming
Programming is an integral part of the operating concept; before you start programming,
read the chapter "Operation: the menu system" at the beginning of this booklet.
Handset
While programming, the handset remains on hook. If you lift the handset during
programming, the programming sequence will be interrupted. If you receive a call during
programming, you must decide whether to answer the call or to continue with the
programming.
Programming mode
You can advance to the beginning of the programming mode in one of two ways:
–
"Long click" of the Menu key (at least 2 seconds)
–
Press the Menu key repeatedly until "Programming" appears; press the Foxkey under
"Programming"
Note
A "long click" of the Name dialling key or the Directory key advances the
program directly to the menu for entries into the private directory.
A "long click" of a variably programmable key advances the program
directly to the programming menu for this key.
Menu key
With the Menu key you can move at two levels: Firstly at the programming level
(PRG 1–…; selection of the "PRG" point that you wish to program, for example, "Keys")
and secondly at its sub-function level (for example, allocation of a Number key). You can
leave both levels by pressing the END key.
Storing
Store the contents of a menu item that you have programmed or changed by pressing the
Foxkey under "Ok". If you press the Foxkey under "Back" or the END key, the
programming will not be stored.
Programming example:
Setting the ringing melody
In the Programming mode press the Foxkey
under "Ring". Select with the Foxkey under
"Melody" and "
¥ ß
" one of the 16 melodies.
Press the Foxkey under "Test" to switch on the
selected melody and confirm the selection by
pressing the Foxkey under "Ok". Return to the
initial state by pressing the END key.
Note
You can adjust the volume and speed of the ring signal in the same way.
Ring
¥ ß
Test
Ok
END
