X-3D-BL User’s Manual
les from top and are fixed with plastic nuts from be-
low. Attention! One side of the CF baseboard is meant
for mounting the R/C receiver. Please make sure that
the orientation is as seen in the following photograph.
The R/C receiver goes on the rear left side of the fra-
me (top view!).
Put the solid CF plate on the booms and fix it with
four plastic screws which go into the previously
mounted brazen bushings.
2.2.5 Lower side of the Core
As seen in the picture, the two magnesium bars have
to be covered by heat-shrink, a silicon hose, rubber
or something similar to protect the battery. Their ori-
entation has to be perpendicular to the R/C receiver
mount.
Slide the O-rings over the lateral magnesium parts as
seen in the picture.
After that, the second magnesium plate is to be placed
in the lower slots of the lateral parts. The orientation
has to be as seen in the following photograph.
The second CF plate with slots in its corners has to be
slid over the lateral parts until it touches the magnesi-
um plate completely.
The two plates are now mounted together using a
plastic screw and a plastic nut.
www.x3d-shop.de
- 12 -
www.asctec.de
