X-3D-BL User’s Manual
Congratulations! You have just finished your X-CSM
Core!
2.2.6 Mounting a battery
The X-CSM Core offers a good protection for your
battery. However, the protection only works if the
battery is attached correctly. If this is not the case,
the battery can be damaged or even destroyed during
a hard crash. The battery can be mounted correctly
using for example a small wooden plate with a hole in
its center. Such a plate can be attached to the battery
using hook-and-loop tape. The hole will engage with
the plastic screw in the center of the Core’s bottom.
Make sure you add some material (e.g. rubber-tape)
to push the battery against the bottom of the Core. It
is important, that the wooden plate touches the lateral
parts of the core, such that the battery can not move
sideways.
Your X-CSM frame is now assembled completely!
Good luck with adding the electronics! :-)
2.3 Mounting the Electronics
2.3.1 Preparing the X-Base
The X-3D spacers have to be screwed to the X-Base.
After that, the spacers for mounting the X-Base itself
have to be fastened using four tapping screws. The
spacers will stick to the screws, even though they can
easily be moved up and down.
In addition, the battery cables have to be soldered to
the appropriate soldering pads. Make sure that the po-
larity is correct!
www.x3d-shop.de
- 13 -
www.asctec.de
