X-3D-BL User’s Manual
2.3.2 Preparing the X-BLDC motor
controllers
Put two tapping screws into the holes and fasten them
using the 4 mm plastic spacers. Make sure the screw-
heads are at the controller’s side with the red cable
attached. Repeat this procedure with all four control-
lers.
2.3.3 Positioning of the X-Base
Put the battery cables through the rubber bushing next
to the receiver-mount. This will be the rear left side of
your X-3D-BL.
2.3.4 Mounting the X-BLDC motor
controllers
Screw the motor controllers to the respective holes in
the booms. Do this by turning the screws alternately
turn by turn, until the spacers touch the boom. Thus
you will not bend the controller boards too much.
The power cables of the controllers are still unconnec-
ted at this point.
www.x3d-shop.de
- 14 -
www.asctec.de
