X-3D-BL User’s Manual
There is
no
additional cable required to transfer data
between the X-3D and the X-Base. Put the top cover
of the X-CSM back in place and fasten it using the
central plastic screw.
2.4 Last steps
2.4.1 Mounting the antenna
The antenna can be assembled as seen in the follo-
wing picture. Use the thinnest heat-shrink that came
with your kit to cover the lower end of the GFK stick
which will hold the antenna wire. Put a silicon hose
with a length of about 2 cm over it. Cut a piece of
about 3 mm length of the thick heat-shrink and use
the remaining (long) piece to cover the silicon hose.
Make sure that the heat-shrink covers the upper end
of the silicon hose and thus prevents it from sliding
off. Fix the antenna wire using a 3 mm piece of the
thick heat-shrink and wrap the wire around the stick.
The end of the antenna can be fixed to the stick using
a short silicon hose. This hose is also used to protect
the peak end of the antenna. Now you can simply sli-
de the antenna’s stand support over the top-screw of
the X-CSM Core. If you want, you can use a metal
screw instead of the plastic screw for more stabili-
ty. Alternatively, the antenna can be put on a longer
screw holding one of the booms, or it could be fa-
stened to one of the lateral parts of the X-CSM core
using two cable ties.
2.4.2 Preparation and mounting of
the propellers
The lower piece of the propeller center has to be re-
moved using a cutter. In addition, the hole has to be
extended using a 3 mm (1/9 inch) drill.
The propellers can then be slid over the axle and be
fastened using a plastic nut. Do not fasten the nut too
tight, as this would bend the propellers.
www.x3d-shop.de
- 18 -
www.asctec.de
