X-3D-BL User’s Manual
2.5 Optional: Integrating the
X-ACC
If you own an X-ACC please attach the spacer to the
X-Base using one of the M2-screws. To do so, insert
the screw in the drill hole in the X-Base and hold
it with one finger from below while you screw the
spacer onto it.
Plug the X-ACC into the socket on the X-Base and
fasten it using the second M2-screw.
2.6 Optional: Integration of the
X-3D Mag
Attention: The X-3D Mag can only be used in
combination with the FunPilot and the X-ACC
module!
The X-3D Mag has to be mounted on the car-
bon fibre panel as shown in the image. The riser PCB
has to look away from the CF panel and has to be
in the corner. Please use the nuts on the top of the
CF panel!
A wrong orientation will lead to wrong
measurements and erratic behaviour!
Now connect the cable to the X-3D Mag and the
FunPilot, place the carbon fibre panel ontop of the
X-CSM as shown in the picture and mount the 3mm
top plastic screw as usal.
Attention:
The X-3D Mag perfomance can be
affected by high current cables close to the sensors.
www.x3d-shop.de
- 20 -
www.asctec.de
