X-3D-BL User’s Manual
The X-3D-BL works with any R/C with at least four
channels. Make sure that all channels work indepen-
dently and that no mixers are active in your remote.
3.2.3 X-3D Parameters
The X-3D offers four preprogrammable parameter
sets which can be selected by jumpers. You can find
four recommended parameter sets in the software
package (.zip-file) you downloaded before in the sub
folder ”X-3D Settings”.
To upload the parameters you have to connect the X-
3D with the USB adapter:
In this case it does not matter if the X-3D-BL is
turned on or off. Click on ”X-3D” in the X-Control
software, choose the correct COM-Port (normally
”Autoselect: COMxx”) and click on ”Connect”. Then
click on ”Parameters”.
You can select a parameter set in the upper left
corner. The image on the lower left shows the jumper
setting which enables the selected setting. Select all
four settings (one after another) and for each of them
load one of the four recommended parameter sets
(e.g. ”X-3D for X-Base - Beginner Setting Vx.x.ini”)
by clicking on ”Load”.
Click on ”Finished” and then on ”Transmit and Dis-
connect” to complete the software configuration of
your X-3D-BL.
3.2.4 X-3D-FunPilot Parameter
The X-3D-FunPilot offers four onboard stored para-
meter sets which can be selected my the RC. To select
a setting make sure, that the motors are switched off
and the UFO has RC reception. The setting is selec-
ted by giving full throttle and moving the pitch/roll
stick to one of the four corners for a second. The UFO
acknologes the selection by 1-4 beeps. The following
image shows the stick positions for the different set-
tings.
The factory set parameters are already prepared for
the X-BL-Ufo. Therefore there is no direct need to
change them. Nevertheless, if you want to change
them connect the X-USB module to the X-3D Fun-
Pilot, switch on the UFO and start the PC software.
Click on ”FP/OSP” and on connect to connect to the
X-3D-FunPilot. Click now on ”OSP Flight parame-
ters”.
www.x3d-shop.de
- 25 -
www.asctec.de
