X-3D-BL User’s Manual
1.1.3 X-3D
The X-3D is the sensor unit of the X-3D-BL. With
three piezo-gyros and highly optimized control
loops it does the actual flight/attitude control. All
parameters influencing the in-flight behavior can be
tuned by connecting the X-3D to a PC using the USB
adapter that came with your X-3D-BL. Once you are
on the field for flying you can select four different
parameter sets using two jumpers.
LED patterns shown by the X-3D
•
red blinking:
Initializing or at least one motor
not detected
•
green:
No reception or playing startup-
melody
•
green:
Ready to fly
1.1.4 X-3D-FunPilot
The X-3D-FunPilot is the new high performance
sensor unit of the X-3D BL UFO. Equipped with
three piezo gyroscopes, a pressure sensor and highly
optimized control algorithms, the X-3D-FunPilot
takes care of the flight control of the UFO. All
important parameters of the X-3D-FunPilot can be
set with the PC software and the X-USB module.
Four different settings can be stored onboard and can
be selected by the RC on the flight field
LED patterns of the X-3D-FunPilot
•
red:
Initialisation
•
red/yellow blinking:
X-Base or X-BL motors
not detected
•
red/yellow and green blinking:
No RC recepti-
on and ne setting selected
•
yellow and green blinking:
No setting selected
•
yellow blinking/green:
Ready for flight
•
yellow blinking:
X-Base is in setup mode
•
yellow/red:
trim reset
•
gelb:
trim saved
1.1.5 Motors
The X-BL-52s motors by HACKER Motors Germa-
ny are custom-built for the X-3D-BL. The motors are
perfectly suited for the application in this vehicle.
www.x3d-shop.de
- 6 -
www.asctec.de
