EN
24
Setting Values
Commissioning procedure
The water in the pool must be clean without any additives.
Ideally fi ll the pool with fresh water from the water main.
1. Ensure the fi ltration system runs NONSTOP for 24
hours
•
Set the required values via the main screen by pressing the appropriate tab
(see the chapter Control):
•
If you have the CLF probe, set the disinfection to 0.0 mg/l.
If you have the REDOX probe, set the disinfection to 000 mV.
•
pH values leave at the factory setting for the time being (pH 7.0).
•
Set ALGICID to 10 ml m
3
per day (see the chapter ALGICID Setting).
•
Set FLOC+C to 10 ml m
3
per day (see the chaper FLOC+C Setting).
2. Close the water supply to the probes
ASIN AQUA Oxygen display “No water supply to the probes” notifi cation.
3. Perform superchlorination
Perform superchlorination of pool water with Super CHLOR (inorganic active
chlorine without stabilizers).
Follow the instructions on the packaging (1 kg = 80 m
3
).
24
Wait at least 1 hour. Optimally up to 24 hours.
If the
concentration is lower
, repeat superchlorination. If the
concentration
is higher
, wait till the chlorine concentration in the water drop down.
4. Open the water supply to the probes
the “No water supply to the probes” notifi cation will disappear from the ASIN
AQUA Oxygen display.
5. pH adjustment
•
Set the
required pH value
ideally close to the pH value of the incoming
water.
•
ASIN AQUA Oxygen adjusts the pH automatically according to the
preset required value.
•
The ideal pH value
should be between
6.8 and 7.5
.
Initial dose:
After the pool installation or restart, dose a recommended initial dose of
OXYPURU and ALGICIDE. In doing so, use the “Test of Outputs” screen which
calculates a required dose according to your pool volume.
SHOCK DOSE
•
If the pool water quality begins to deteriorate during operation, use the initial
dose function for shock dosing of OXY PURE and ALGICIDE.
SuperCHLOR
