Asentria SiteBoss 530 User Manual
32
SiteBoss 530 - Caller ID Security
A) Enable [OFF]
B) Caller ID 1 []
...
U) Caller ID 20 []
V) Add Number From Log List
Note:
Caller ID must be available on the phone line connected to the S530 for this feature to work.
Enable
is an ON/OFF toggle to enable caller ID restrictions. When enabled, the S530 will only answer the
modem if caller ID indicates one of the allowed phone numbers is connecting. Default setting is OFF.
Caller ID n
allows you to add or change a specific phone number. You are allowed to use simple wildcards in
phone numbers: An asterisk (*) wildcard allows for any number of digits to appear to the right of that position. A
question mark (?) matches any single digit. If no numbers are defined in this menu, all incoming calls are
accepted. (Max length 47 chars)
Add Number From Log List
displays a list of phone numbers that have recently dialed into the S530 for addition
to this list.
Wireless Modem
SiteBoss 530 - Wireless Modem Settings
A) Mode [OFF]
B) APN []
C) PIN []
D) Idle Timeout (minutes) [5]
E) Band (GPRS only) [DUAL-850/1900]
F) PPP/Wireless User Name []
G) PPP/Wireless Password [********]
H) Default Route Enable [OFF]
Note:
If the optional wireless modem Expansion Card is not installed in the S530, this menu is displayed, but
changing any of the settings will not do anything, except for the PPP/Wireless User Name and Password settings
(see below).
Note:
For a complete description of the setup and operation of the wireless modem, please refer to the
chapter later in this manual.
Mode
toggles between OFF (disable modem), PERMANENT (maintain “always-on” connection with modem), and
CIRCUIT–SWITCHED. Default setting is OFF.
APN
sets the Access Point Name (APN) as defined by your wireless provider. Default setting is “ “. (Max length
is 31 chars)
PIN
sets the PIN associated with the SIM card (if any). Default setting is “ “. (Max length is 15 chars)
Idle Timeout
sets the number of minutes (3 – 255) to wait before disconnecting an inactive modem connection.
The purpose of this setting is to allow the modem to get reset after a period of inactivity to ensure the modem
connection is working properly. Default setting is 5 minutes.
Band (GPRS only)
toggles between DUAL - 850/1900, DUAL – 900/1800, DUAL – 900/1900, MONO – 850,
MONO – 900, MONO-1800, and MONO – 1900. This sets the GSM bands on which the modem will operate.
Default setting is DUAL - 850/1900.
Summary of Contents for SiteBoss 530
Page 6: ......