Asentria SiteBoss 530 User Manual
24
Static routes are network routes that specify in a more or less permanent way (
static
) that traffic to a certain
destination (destination host or destination network) gets
routed
out a certain interface or via a certain gateway.
Static routes gives you the ability to fine-tune how outbound network traffic leaves the unit for up to eight different
routes.
Enable
is an ON/OFF toggle to enable a static route. Default setting is OFF
Destination Network
is the network notation, i.e., w.x.y.z/s, where s is the significant bits. Default is 0.0.0.0/0.
Gateway
is the IP address of the gateway. Default setting is 0.0.0.0
Interface
displays a listing from which to select any one of the interfaces available on this S530 – None, Ethernet
1, Ethernet 2, Dialup Modem PPP, and Wireless Modem PPP. Default setting is NONE.
Refer to the
section in the Features chapter for a detailed explanation of Static Routes.
DSL Settings
SiteBoss 530 - DSL Settings
A) Start Mode [MANUAL]
B) Type [PPPOA]
C) VPI [0]
D) VCI [0]
E) Encapsulation [VCM]
F) Mode [BRIDGED]
G) Username []
H) Password [********]
I) IP Address [0.0.0.0]
J) Mask [0.0.0.0]
K) Router [0.0.0.0]
Following describes the menu options for configuring the optional ADSL Modem. For more information regarding
the operation of the ADSL modem, Setting Keys, DSL Routing example, and DSL Glossary, please refer to the
chapter later in this manual.
Start Mode
toggles between MANUAL and AUTO to set how the DSL interface is to be raised. Set this to
MANUAL to require user intervention to raise the DSL interface, or to let a VPN (if it is configured to use DSL)
raise the DSL interface when the VPN needs to use DSL. Set this to AUTO to tell the unit to automatically raise
the DSL interface upon boot. Default setting is MANUAL.
Type
toggles between PPPoA, PPPoE, STATIC, or DHCP. This should be set as directed by your ADSL
provider. This is the most important DSL setting since its value determines what other DSL settings are
applicable to the DSL configuration. Default setting is PPPoA.
VPI
sets the
(Virtual Path Identifier) used on the DSL interface. This should be set as directed by your ADSL
provider and is required for DSL operation. Values are: 0 to 4095 Default setting is 0.
VCI
sets the
(Virtual Channel Identifier) for the DSL interface. This should be set as directed by your ADSL
provider and is required for DSL operation. Values are: 0 to 65535. Default setting is 0.
Encapsulation
toggles between VCM and LLC to control whether the encapsulation is
(Logical Link Control)
(Virtual Channel Multiplexed). This should be set as directed by your ADSL provider and is required for
DSL operation. Default setting is VCM.
Mode
toggles between BRIDGED and ROUTED to control whether the DSL is set up for Bridged mode or Routed
mode when the DSL type is STATIC. Default setting is BRIDGED.
Summary of Contents for SiteBoss 530
Page 6: ......
