Asentria SiteBoss 571 UserManual
Page 18
Dispatcher
Send a Dispatcher alarm via a POTs modem to a number specified by index number, which can be configured in
the
DISPATCH(PHONE#
or
INDEX#)
Email
Send an email notification to an address specified by index number which can be configured in
menu or delineated in the action.
EMAIL(EMAIL OR INDEX#)
Group
Group is used to identify this action list as part of a group identified by group name, not currently used.
GROUP(GROUPNAME)
ID
Identify this action by a descriptor, for reference in other action.
ID(IDNAME)
Inform
Send an SNMP inform to a specific IP address or index which refers to an IP address or host name configured in
the
INFORM(IPADDRESS OR INDEX#)
Malert
Malert sends a malert (Asentria Alarm via modem) to a number specified by index number, which can be
configured in the
MALERT(PHONE#
or
INDEX#)
Modem
Make the unit dial a phone number via the POTs modem to a specified index number, which can be configured in
the
menu, and start a login session (to the unit's command processor) with the answering
machine.
MODEM(PHONE#
or
INDEX#)
Postpone
Postpone an already-running action identified by idname for a duration specified by seconds.
POSTPONE(IDNAME, SECONDS)
Pause
Pause operation for a duration specified by seconds.
PAUSE(SECONDS)
Power
Using this action puts a power output into a defined state, determined by the action parameter.
Action: one of the following two words, by case-insensitive exact match:
ON
or
OFF
EventSensor: the number of the EventSensor that has the specified output, where it is the same as that referred to
by the index in an EventSensor key (e.g., 200 in event.sensor[200].* for the internal EventSensor) as well as that
referred to by the SNMP esIndex object.
Point: the number of the output (1-based) on the specified EventSensor. E.g., this is the same number x in
"event.sensor[200].output[x].*"
POWER(ACTION, EVENTSENSOR, POINT)