16
AEU-350 / AEU-350S
Air Filter Replacement
A
Exhaust air from the unit passes through a foam air filter to reduce
airborne particulates. It is recommended to replace the air filter
annually. The air filter
A
is located in the gap between the lower
chassis and the case on three sides. Remove by pulling the foam
filter out with your fingers. Install the new filter by pushing it into
the gap, ensuring that the filter is flush against all edges.
REPACKING
1
Remove all water/waste and clean/sterilize the unit as
instructed in
Maintenance and Sterilization
, page 14.
2
Unplug the power cord and coil.
3
If used, unclip the detachable 4-position and scaler instru-
ment holders from the case, then retract the handle.
4
Tip the unit on its back. For shorter trips and quicker set up, all
instruments can be stowed in their holders, as shown
A
, with
hoses and cables remaining connected to the bulkhead. For
longer trips and more secure storage, the ejector valves/hoses
and motor/cord can be disconnected and stowed in the hose
storage pouch, as shown
B
.
A
B
Use caution when closing the case to avoid pinching cords or
damaging accessories.
