Aseptico ADC-02CF, Operation/Maintenance Manual & Schematic Set

11

ADC-02CF

REPACKING THE CHAIR

1. 

ARM SLINGS:

 Remove the arm 

slings from the ends of the arm 

posts, then tuck the arm slings 

into the frame on the rear of 

the backrest.

2. 

ARM POSTS:

 Rotate the arm 

posts down just below the seat 

frame, then fold in the hand 

grips (Fig. 25 

A

). 



Make sure the hand grips are 

positioned 

below

 the seat 

frame before proceeding or damage to the upholstery may 

occur when folding the leg and foot panels closed.

3. 

FOAM & PANELS:

 Place a 

piece of foam (Fig. 26 

A

) over‑

lapping the seat and backrest 

panels. Tie two small pieces 

of foam (Fig. 26 

B

) around the 

arm post pivots. Fold the foot 

and leg panels closed onto 

the seat panel. 

4. 

BACKREST PANEL:

 Flip the 

pillow (Fig. 27 

A

) over to the 

rear side of the backrest. 

Detach the backrest latch 

from the cylinder, then fold 

the backrest down onto the 

seat panel.  

5. 

LOWER CHAIR:

 Press and hold the selector lever in the SEAT 

LOWER position until the seat frame touches the floor. If the 

seat frame won’t lower all the way, press down on the lift lever 

and hold it there while simultaneously holding the selector 

lever in the SEAT LOWER position.

6. 

SELECTOR LEVERS:

 If the selector levers are in the extended 

position, retract each one by pushing in on the locking button, 

then sliding the selector lever in until the locking button pops 

out of the inner hole on the selector lever tube.

7. 

BACKREST STRAP:

 Tuck the 

pillow down between the 

chair framework. Guide the 

backrest strap  (Fig. 28 

A

) 

under the main lever frame 

and over the top of the back‑

rest, then fasten the strap 

securely.

8. 

STABILIZER BAR:

 Fully 

retract the stabilizer bar.

9. 

LOADING CASE:

 Using two 

people, lift the chair and 

place it into the transport 

case. Make sure to position 

the headrest end (Fig. 29 

A

)

of the chair towards the label 

(Fig. 29 

B

) inside the case to 

prevent the chair from get‑

ting scratched by the rivets on the inside of the case. 

10. 

LOCKING CASE:

 Place the lid 

on the case and close all 10 

latches (Fig. 30 

A

). The case 

is equipped with wheels for 

easy transport.

• ALWAYS LIFT THE CASE USING THE HANDLES PROVIDED.

• ALWAYS LIFT THE CASE USING THE HANDLES PROVIDED.

• WHEN TRANSPORTING CHAIR, DO NOT PLACE HEAVY OBJECTS ON 

• WHEN TRANSPORTING CHAIR, DO NOT PLACE HEAVY OBJECTS ON 

TOP OF THE CASE.

TOP OF THE CASE.

 CAUTION

Fig. 25

Fig. 25  

A

Fig. 26

Fig. 26  

A

B

Fig. 27

Fig. 27  

A

Fig. 28

Fig. 28  

A

Fig. 29

Fig. 29  

B

A

Fig. 30

Fig. 30  

A