TABLE OF CONTENTS:
Package Contents . . . . . . . . . . . . . . . . . . . .i
Introduction . . . . . . . . . . . . . . . . . . . . . . . . .1
Setting Up the Unit . . . . . . . . . . . . . . . . . . .1
Operation . . . . . . . . . . . . . . . . . . . . . . . . . . .3
Maintenance . . . . . . . . . . . . . . . . . . . . . . . .5
Warranty . . . . . . . . . . . . . . . . . . .Back Cover
Size:
12.5” x 17.5” x 7.5”
(32 cm x 44 cm x 19 cm)
Weight:
32.6 lbs (14.8 kg)
Power Source:
115 VAC, 60 Hz or
230 VAC, 50 Hz
Current Rating:
6.3A at 115 VAC or
4A at 230 VAC
Fuse:
115V Operation:
6.3A, 125V
Medium Time Delay
230V Operation:
4A, 250V Slo-
Blo Type
Air Source:
1/2 H.P. Oil-Free
Compressor/Vacuum Pump
Water Supply Tank: 900 mL (0.95 Quart)
Waste Tank:
946 mL (1 Quart)
Vacuum:
1.35 CFM @ 4.0 In. Hg.
Environmental Conditions:
Intended for indoor use in an office environment of
10°C - 40°C, 10% - 90% humidity, non-condensing.
SPECIFICATIONS:
#TA-1
TA-1 Syringe Tip
#AA-12A
Handpiece Holder
Extension Arm
#AA-12CSB
Case Stand-Off
Bracket
#AA-12HVE
HVE Tip Adapter
#AA-26SS
Stainless Steel
Dry Oral Cup
Available Accessories:
PACKAGE CONTENTS
ADU-12DCEB System Case/Control Box
Highspeed and Lowspeed Handpiece Controls
TA-90D 3-Way Air/Water Syringe with Tip
NWS-8 Water Supply Tank
730068-08 Waste Container
Electric Foot Switch
Saliva Ejector Vacuum System
Remote AC Power Cord
AA-12CSB Case Stand-Off Bracket
Two (2) Extra Fuses
Shoulder Strap
Manual
P.O. Box 1548 • Woodinville, WA 98072
8333 216
th
Street S.E. • Woodinville, WA 98072
International (425) 487-3157 • Toll Free (800) 426-5913
www.aseptico.com • info@aseptico.com
i
To prevent injury to people and damage to
property, please heed relevant warnings and
remarks. They are marked as follows:
WARNING:
Serious injury or death may result if
ignored.
CAUTION:
Damage to property or the
environment may result if ignored.
NOTE:
Important additional information
and hints.
WARNING: This device has been tested and found to comply with
the emissions requirements of IEC 60601-1-2:2001-09. These
requirements provide reasonable protection against harmful
electromagnetic interference in a typical medical installation.
However, high levels of radio-frequency (RF) emissions from
electrical devices, such as cellular phones, may disrupt the
performance of this device. To mitigate disruptive electromagnetic
interference, position this device away from RF transmitters and
other sources of electromagnetic energy.
WARNING:
Device not suitable for use in the presence of
flammable gasses or gasseous
oxidizers.
