5
AEU-1000-70V / AEU-1000
SYSTEM SETUP
This section provides step-by-step instructions for setting up the unit.
The handpiece, motor/cord assembly, and irrigation tubing set
must be sterilized before each procedure as instructed in the
Maintenance and Sterilization
section (page 10).
1 .
Unpack the unit and identify each of the components shown
to the left (page 4).
2 .
Insert the bag hanger
A
into the hole on top of the console.
Make sure that the tab
B
on the hanger fully enters into the
slot
C
on the console, locking the hanger in position.
A
B
C
3 .
Plug the power cord
A
into the power inlet on the back of the
console, then plug the other end of the power cord into a hos-
pital-grade, grounded electrical outlet.
A
4 .
Connect the foot controller plug
A
(for either the AE-7PM
or AE-70V2 foot controller) to the socket on the back of the
console.
The foot controller plug is “keyed” to the socket and
can only be inserted in one position, with the notch
B
pointing to the left. Hold the plug against the socket and
rotate it until you feel the plug enter the socket, then turn
the locking sleeve clockwise until it clicks to secure the
connection.
A
B
5 .
Connect the motor plug
A
to the socket on the front of the
console.
The motor plug is “keyed” to the socket and can only be
inserted in one position, with the larger tab
B
pointing up.
Hold the plug against the socket and gently rotate it until
you feel the plug enter the socket, then turn the locking
sleeve clockwise to secure the connection.
A
B
6 .
Install an AHP-85MB-X or AHP-85-SS 20:1 handpiece
A
, or an
AHP-64 1:1 handpiece (handpieces purchased separately)
onto the motor
B
.
A
B
