7
AEU-1000-70V / AEU-1000
13 .
With one hand, pull the irrigation tube firmly from the bottom
of the pump door
A
. Use the other hand to guide the irriga-
tion tube into the notch
B
on the console while closing the
pump door.
A
B
14 .
Attach the small end of the irrigation tube
A
to the handpiece
irrigation fitting, following the instructions that came with
your handpiece. Attach the irrigation tube to the motor cable
at evenly spaced intervals using the AHP-03 clips
B
provided
in the AE-24 tubing set bag.
A
B
15 .
Hang a saline bag (1000ml max.) from the hanger with the
saline port pointing towards the rear of the console. Swing
the bag away from the console (to prevent dripping on the
console) then spike the saline bag with the bayonet
A
. Wipe
up any spills on the console immediately.
A
16 .
Press the power switch
A
on the rear of the console to the
on (I) position to turn the unit on.
A
Handpiece Selection Screen
17 .
The
handpiece selection screen
is displayed each time the
unit is powered on. Use the
and
buttons
A
to select the
handpiece model that you will be using (see table below).
When the
code
for your handpiece model is displayed in the
top segment of the screen
B
, press the “AHP” segment of the
screen
C
to confirm your selection and activate the unit.
HANDPIECE MODEL
PRESS
CODE DISPLAYED
AHP-85-SS (20:1)
85-SS
AHP-85MB-X (20:1)
OR
AHP-64 (1:1)
85-MB
B
A
C
If you switch to a different handpiece model, you must
turn the unit off, then back on, to access the handpiece
selection screen.
18 .
Calibrating the handpiece takes about 20 seconds and should
be done every time you turn the unit on or change hand-
pieces. See
Calibrating the Handpiece
on page 9, after becom-
ing familiar with the layout of the control panel.
