2
SETTING UP THE UNIT:
1. Plug the AEU-10 console into a
standard 120 Volt AC grounded power
outlet. (220 Volt AC unit is also
available)
2. Plug the micro motor into the
receptacle on the front of the console
labeled 'motor'. Make sure the power
switch on the console is turned off.
3. Attach the straight handpiece to the
motor by sliding straight onto the
motor shaft. Insert a bur or bit into the
handpiece collet. Only operate the
unit with a bit or blank installed and
with the collet in the closed position.
4. Attach AE-7P on/off foot pedal to the
receptacle on the back of the unit
marked “Foot Switch”. The AE-7P foot
pedal is standard with the AEU-10SS
and optional with the AEU-10C. The
variable speed AE-14A foot control is
also available.
Motor
Handpiece
Bit
Console
Motor Holder
Figure 1
Foot
Pedal
On / Off
Switch
‘ON’
Indicator
Foot Switch
Receptacle
AC Power
Inlet
Motor
AHP-101
Handpiece
Bit
(Close Collet)
Fuse Holder
