OPERATION:
1. Turn the power switch to the 'ON'
position. When switched on, the
L.E.D. 'ON' indicator should light.
2. Select the proper running speed by
turning the 'SPEED' dial. Turn the dial
clockwise to increase speed, and
counterclockwise to decrease speed.
3. When running the handpiece,
DO NOT force or stall the motor. If the
motor stalls due to excessive
pressure, release pressure
immediately and use a light touch.
4. If equipped with a foot pedal, select
“Foot” with hand/foot selector and
press foot pedal to operate. Foot
pedal must be unplugged and selector
must be moved to “Hand” to return to
hand mode.
Figure 2
POWER
SWITCH
'ON'
INDICATOR
HAND/FOOT
SELECTOR
SPEED
DIAL
MOTOR
RECEPTACLE
FWD/REV
SELECTOR
NOTE:
If motor stops due to an open collet
or excessive pressure:
1. Turn Power Switch off
2. Let unit cool down for 2-4 min.
3. Turn Power Switch on
4. Resume use
WARNING:
• Do not attempt to disassemble the
motor or motor connector.
• Do not oil or lubricate the motor.
• Do not attach a handpiece to the
motor while the motor is running.
• Do not bend motor cord sharply.
Failure to comply with any of the above
instructions may void your warranty
CLEANING THE CONSOLE:
The exterior of the console may be cleaned
by wiping with a soft cloth moistened with
mild detergent or disinfecting solution.
3
