4
To Install Bit:
1.
Open collet by turning grip 1/4 turn as
shown in
Fig. 4
until you feel a
“click”. The gap between the grip and
handpiece retainer will narrow when
the collet is open.
2.
Insert bit fully into collet.
3.
Close collet by turning grip 1/4 turn
as shown in
Fig. 3
NOTE:
Before use, check to insure that bit is
fully inserted and grip is firmly secured
in locked position.
HANDPIECE:
The Aseptico AEU-10 System includes the AHP-101 straight handpiece. This handpiece
features a quick-twist chuck that will accept any standard HP (3/32") shank bit (or bur)
or any Doriot style attachment.
To Remove Bit:
1.
Open collet by turning grip 1/4 turn
as shown in
Fig. 4
until you feel a
“click”.
2.
Push bit back into collet and turn to
release.
3.
Pull bit straight out of collet.
Bit Collet Grip Gap Retainer
Close Collet
Insert Bur
Open Collet
Push, Turn,
and Pull Bur
Sterilization:
The AHP-101 steam autoclaving sterilization procedure provided below has been
independently validated to achieve a sterility assurance level (SAL) of 10
-6
.
This handpiece must be sterilized before initial use and between each patient use per
the following procedure:
•
Scrub dirt and other debris from handpiece
and wipe clean with a cotton swab or
cloth.
•
Autoclave
at 132°C (270°F) for ten minutes.
•
Do not rinse or submerge
in any solution, or use ultrasonic cleaners.
•
Do not lubricate.
The sealed bearings in this handpiece eliminate the need for
lubrication.
Figure 3
Figure 4
