8
REvERSE BEEPER
1=on, 2=off, 3=esc
When the Reverse Beeper (BPR) feature is active,
an audible beep will sound when the handpiece is
rotating in the reverse direction. This is a system-
wide setting and is not saved on a Preset Button
when programming.
• To enable the Reverse Beeper feature, press 1.
• To disable the Reverse Beeper feature, press 2.
• To exit the System Setup Menu without changes,
press 3.
SAvE CHANGES
selection will appear.
Select 1 to save changes and exit or select 2 to
reject all changes and exit.
TORqUE WARNING TONE
1=on, 2=off, 3=esc
When the Torque Warning feature is active, a
chirping warning noise will be audible when the
torque level reaches approximately 75% of the
selected torque limit. This is a system-wide setting
and is not saved on a Preset Button when
programming.
• To enable the Torque Warning Tone,
press 1.
• To disable the Torque Warning Tone,
press 2.
• To exit the System Setup Menu without changes,
press 3.
SAvE CHANGES
selection will appear.
Select 1 to save changes and exit or select 2 to
reject all changes and exit.
ACCESSORy WARNING TONE
1=off, 2=on, 3=esc
When the Accessory Warning feature is active, a
warning tone will be audible when a GT Accessory
file or ITR Emulation Accessory file is in use. This is
a system-wide setting and is not saved on a Preset
Button when programming.
• To disable the Accessory Warning, press 1.
• To enable the Accessory Warning press 2.
• To exit the System Setup, press 3.
SAvE CHANGES
selection will appear.
Select 1 to save changes and exit or select
2 to reject all changes and exit.
SlEEP MOdE
1=on, 2=off, 3=esc
After 20 minutes of inactivity, the Endo DTC
®
will enter Sleep Mode to conserve power. In
Sleep Mode, the lighted Console LCD display
will turn off and the green LEDs above the
CAL, FWD/REV, and MAX buttons will blink
once every second.
To resume normal operation when the Endo
DTC
®
is in Sleep Mode, press any button on
the console or press the foot control.
This is a system-wide setting and is not saved
on a Preset Button when programming.
• To enable the Sleep Mode, press 1.
• To disable the Sleep Mode, press 2.
• To exit the System Setup, press 3.
SAvE
CHANGES
selection will appear. Select 1 to
save changes and exit or select 2 to reject
all changes and exit.
7. POWER SWITCH:
Controls power on/off to console. On the
switch, the on position is represented by a
‘1’ and the off position is represented by a
‘0’. When the AEU-25 is turned on and not
in Sleep Mode (see System Setup Menu
page 6), the Console LCD Display will light.
SySTEM SETUP MENU - CONTINUEd:
