SETTING UP THE UNIT:
1.
Remove the Console from the
Carrying Case and check that the
voltage is proper for the country of
use.
Use 110V for 110-120V 60Hz
voltages, and 220V for 220-250V
50Hz voltages.
For alternative voltages (220V-
250V), confirm that the type of plug
cap is correct for the country of
usage and carries the proper
certification markings.
The correct Power Cord for the
specified voltage is shipped with
the console.
2.
Attach the Power Cord to the
back of the Console and plug into a
grounded electrical receptacle.
3.
Connect the Motor to the Motor
Receptacle on the front panel of
the Console.
4.
Attach the AHP-101 Handpiece or
other “E” Type Handpiece to the
motor. If using the AHP-53 Doriot
Handpiece, attach it to the Doriot
Connection on the front of the
AHP-101 Handpiece.
5.
Insert a bur or bit into the
Handpiece Collet as shown in the
Handpiece instructions.
Do not
operate the unit without a bur or
blank installed in the collet.
6.
Attach the included AE-7P On/Off
Foot Switch to the connector on the
back of the unit marked 'Foot
Switch'.
2
POWER
CORD
AEU-08D
CONSOLE
AE-5C-30 MOTOR
AE-7P FOOT
SWITCH
“E” TYPE
HANDPIECE
MOTOR
3
MOTOR
HOLDER
AHP-101
HANDPIECE
AHP-53
HANDPIECE
CARRYING CASE ALSO INCLUDED (NOT SHOWN)
OPERATION FUNCTIONS:
1. Power Switch
- Controls power on/off to
console. When the AEU-500 is turned
on, the green Power Indicator LED next
to the Power Switch will light.
2. Speed Control Knob
- Controls the
speed of the Motor and Handpiece. Turn
the Speed Control Knob clockwise to
increase the speed. Turn the Speed
Control Knob counterclockwise to
decrease the speed. The AEU-500 is
capable of a minimum speed of 5,000
RPM and a maximum speed of 30,000
RPM.
3. Mode Switch
- Sets the unit to activate
from a Foot Switch or from the Power
Switch. If using the foot switch, set the
mode to 'FOOT'. Set the mode to
'HAND' to activate whenever the power
switch is on.
4. Rotation Switch
- Selects clockwise or
counter-clockwise rotation of the bur.
Set the switch to 'Fwd' for normal
clockwise operation and to 'Rev' for
counterclockwise operation. Do not
change rotation while bur is turning.
5. Foot Switch
- Controls the on/off
activation of the Motor and Handpiece.
The AEU-500 is shipped with the AE-7P
On/Off Foot Switch. Plug the foot switch
into the Foot Switch Receptacle on the
back of the Console and select 'Foot'
mode for proper operation.
