17
3.
The ‘
T
’ pad (Upper right -
Lavender) increases the torque
setting by 2 N•cm each time the
pad is pressed, up to a maximum
increase of 10 N•cm’s. Once the total
increase in torque reaches this 10 N•cm
threshold, the unit will cycle the next torque
setting back down to its initial (lowest) set-
ting. For example, repeated pressing of the
pad will increase the torque by 2/4/6/8/10
N•cm, then automatically recycle back to
2/4/..etc.
4.
The ‘
P/S
’ pad (Lower left – Orange)
cycles through System Presets 1 -
6. Each press of the pad selects
the next preset.
5.
The
Pump On/Off
pad (Lower right
– Teal) turns pump On and Off, just
like the console button.
6.
The center
Variable Pedal
can be operated
in either the ‘Variable
’
or ‘On/Off’ modes,
depending on which option is selected dur-
ing Setup.
a. Variable Mode
- Motor speed is propor-
tional to how far the pedal is depressed.
Depress to gradually increase speed;
release to decrease speed.
b. ON/OFF Mode
- Foot pedal will switch
the Motor ‘On/Off’ when depressed/
released approximately halfway.
Handle Installation/Removal:
7.
The Foot Switch Handle may be installed to
allow the user to reposition or move the Foot
Control more easily.
a.
Grasp vertical guide rods and carefully
push handle straight into Switch base (see
Figure 12). To remove, pull rods straight out.
Fig.12 - Handle Installation/Removal
A
AE
E--7
7P
PM
M F
FO
OO
OT
T C
CO
ON
NT
TR
RO
OL
L
(AEU-7000 only)
The AE-7PM Foot Control is provided as
standard equipment on the AEU-7000
System. The AE-7PM is used to turn the
motor and pump (when activated) On/Off.
The AE-70V Variable-Speed Foot Control is
available on the AEU-7000 System as an
option.
AE-7PM Installation:
Attach the Foot Control cable to the con-
nector on the back of the Console. Note
keyway on connector. Turn locking sleeve
clockwise to secure cable to connector.
Fig.13
AE-7PM FOOT CONTROL
(AEU-7000 only)
