Page 18
Each System has the ability to load software updates
and enhance its functionality, should this be desired. A
card slot, labeled “Memory Card Port”, is provided on
the back of each unit (see Fig. 33). This Port accepts
memory cards, PN’s MC-7000L (7000L) or MC-7000E
(7000E), which are very similar to those used in
common consumer devices. These cards, available
from Aseptico, enable a user to update software or
replace existing software that might have been
accidentally erased or corrupted. Contact Aseptico for
more information on card usage and availability. To
reprogram a unit, follow the Steps below:
Programming Steps:
1.
Turn ‘Off’ the Main Power Switch on the back panel.
2.
Grasp the right-hand end of the rubber dust cover for
the Memory Card Port and pry open the cover to
expose the card slot.
3.
Insert the new MC-7000L or MC-7000E memory card
into the slot with label facing upward (card terminals
should face downward). Carefully and slowly press
card inward until a ‘click’ is felt, then release the card.
4.
Turn the Main Power Switch (on the back panel) ‘On’.
5.
The Display will show the following message:
• Press the ‘Yes’ key on the Control Panel.
6.
The Display will then show the following message:
• Press the ‘Yes’ key on the Control Panel.
7.
The Display will show the following message:
• A status bar will indicate the progress of the
programming.
8.
When the programming is complete, the Display will
show the following message:
• Press the card inward slightly, then release it to eject it.
When the card is ejected, the System will reset with
normal power-up screen displayed.
9.
Remove the memory card and store it in a safe place.
Close the rubber dust cover on the Memory Card
Port.
In the event that the programming procedure is
interrupted, the unit will display the following
message:
Then:
Re-start the programming procedure from Step #1
(Remember to turn main power ‘Off’ before
reprogramming).
REPROGRAMMING SYSTEM SOFTWARE
Figure 33
Memory Card Detected.
Re-program? (Yes / No)
Presets will be erased!
Continue? (Yes / No)
Programming...
Programming successful.
Eject card.
Programming Failed
Console Software Error.
Re-program unit.
MEMORY
CARD
DUST
COVER
