4
BLOWER ASSEMBLY-OPTIONAL
INSTALLATION
1. Remove the Panel (A) using tin snips or knock out using a hammer and chisel careful not to distort
the mounting surface.
2. Attach the Blower Mounting Box (B) to the rear of the unit using four(4) of the supplied #10 screws.
3. Then mount the Blower Assembly with the four(4) remaining screws.
OPERATION
1. Rotating the rheostat control knob clockwise will turn ON the blower.
2. When turned on, the blower comes on HIGH, then as the knob is rotated clockwise, the blower
speed reduces.
3. Rotate the knob counter-clockwise to turn OFF.
Caution! Route the Power Supply Cord away from the heat source and out of high traffic
areas.
CABINET DOOR KNOB ASSEMBLY
The cabinet door knob is mounted on the inside of the cabinet door to facilitate shipping and
must be removed and re-installed for proper usage.
To get the cabinet door open, place your hand under the cabinet frame (right hand side of the
cabinet door) and push door out.
FOLLOW THESE INSTRUCTIONS FOR DOOR KNOB ASSEMBLY:
1. Remove the machine screw and the door knob.
2. Place the knob on the outside of the cabinet door, re-install the machine screw and tighten being
careful not to strip out the threads in the plastic handle.
INSTRUCTIONS FOR LATCH OPERATION
Follow these instructions to operate you unit safely when operating the
feed door.
1. Turn handle clockwise to the 12 o’clock position (A), pull the door open
until you engage the second step (B).
2. Hold the door in that position for approximately 10 seconds.
3. Then to open door, turn the handle counter clockwise to the 9 o’clock
position (C) and then continue to pull the door open. (D)
4. To close and latch the door, reverse steps 1 thru 4.
HOW TO OPEN THE TOP LID
CAUTION! DO NOT OPEN OR CLOSE THE TOP WHEN THE HEATER IS HOT!
To open,
grasp the top at the front or on each corner and lift all the way up until the support rod
stops the motion. Then gently lower the top allowing the support rod to settles in the cup, holding
the top open.
To Close
, lift the top until the support rod is out of the cup. Pull the rod forward and lower the lid
closed.
THERMODISC KIT FOR B36 BLOWER - OPTIONAL
Wish your blower would turn ON and OFF as the heater gets warm and cold? It can with this optional
kit from U.S. Stove. It connects in line with your power supply cord and mounts to the back of the
heater. When the snap disc reaches 120 degrees, the blower automatically turns ON and turns itself
OFF if it reaches 90 degrees. See your Dealer for details or call U.S. Stove directly.
ASSEMBLY INSTRUCTIONS
MACHINE SCREW
CABINET DOOR KNOB
A
B
C
D
NOTE:
During opening and closing of the feed and ash doors of this
heater, it may seem that the fit of the door is "too tight". As the heater
is fired, the gasketing "settles" or "seats" itself in the door. The tight fit at
the factory and before the heater's initial firing is to insure a good seal
after the gasketing "settles".
