Ashley KP130, Manual

-9-

Control Panel Overview

Turning the heater “On/Off”, as well as adjustments for the fuel feed rate and room fan speed are performed by pressing 

the appropriate button(s) on the control panel which is located on the lower left-hand side of your heater.

ON/OFF

Pressing  the  “On”  button  on  the  control  panel  will  begin 

the  start-up  sequence  for  the  heater.  Fuel  will  begin  to 

feed through the auger feed system then ignite after 

approximately  5  minutes.  Pressing  the  “Off”  button  on  the 

control  panel  will  cause  the  heater  to  enter  its  shut-down 

sequence. The fuel feed system will stop pulling fuel from the 

hopper  and,  once  the  fire  goes  out  and  the  heater  cools 

down, the fans will stop running.

HEAT RANGE

Pressing the “Heat Range” arrows, up or down, will adjust the 

amount of fuel being delivered to the burnpot.

DRAFT FAN

The  draft  fan  (exhaust)  will  come  on  as  soon  as  the  “On” 

button is pressed. The fan will automatically adjust its speed in 

accordance to the heat range setting. However, this speed 

can  be  manually  operated  by  pressing  the  “Draft  Fan” 

arrows  up  or  down.  “Draft  Fan”  when  pressed,  the  display 

will show “Df-A”, which is automatic. Press the arrows again 

to adjust fan speed. When the heater is in the manual mode, 

the optional thermostat will not properly control the unit. 

When adjusting the draft fan setting, try only 1 setting above 

or below the heat setting. It is better to leave the stove in the 

automatic mode.

ROOM FAN

The room fan will come on once the unit has reached 

operating temperature. By pressing the “Room Fan” buttons, 

the  display  will  show  “Rf-A”  which  is  automatic  or  “Rf-1” 

through “Rf-9” for manual settings. In auto mode, the room 

fan’s speed will automatically be adjusted in accordance 

with the heat range setting. By pressing the “Room Fan” up 

arrow, you can adjust the fan speed setting up to “Rf-9”. The 

room fan must operate at a level greater than or equal to 

the heat range setting.

AUX - USED TO RETURN THE STOVE TO THE FACTORY SETTINGS

To return the stove to it’s original factory settings, press and 

hold the “Aux Up” and “Aux Down” buttons simultaneously 

for 3 seconds.

AUGER DELAY

The “Auger Delay” button can be used to pause rotation of 

the Auger for approximately 1 minute. This can be cancelled 

by pressing the “On” button. The “Auger Delay” is normally 

used only during the start up cycle to slow the fuel delivery 

down during the initial ignition.

MODE - The “Mode” button is not used on this model.

During normal operation, the unit is constantly monitored 

for problems. In the event of an error condition, the unit will 

stop and an error will be displayed. See the list of error codes 

found at the end of this manual.