ELECTRICAL
HEAD/SIDELAMPS
REAR REGISTRATION LAMP
REAR HIGH LEVEL LAMPS
INTERIOR SALOON LAMPS
ENTRANCE AND CAB LAMPS
FRONT MARKER LAMPS
REAR LAMPS
SIDE REPEATERS
FRONT DIRECTION INDICATORS
Access to the head/sidelamp bulbs is via removal of the headlamp
bezel and headlamp units.
Remove the two screws securing the lamp to the vehicle. For access to
the bulb, remove the rubber cover at the back of the lamp. When
refitting ensure that the lens is seated and sealed to the rubber cover.
Each of the rear lamps are individual units for each function, ie:- tail,
brake, reverse, direction indicator and rear fog. In each instance undo
and remove the four screws holding the unit to the vehicle. Remove the
unit. Access to the bulb is via the rear of the unit.
NOTE: The back of the rear lamps are sealed and the lens cannot be
removed from the lamp body.
Unscrew and remove the lens/cover to gain access to the bulb.
Undo the two screws and remove the lens for access to the bulb. When
refitting the lens, ensure that it is seated and sealed onto the body of the
lamp unit.
Access to the rear registration lamp bulb is through the right hand
access door at the rear of the vehicle saloon. The registration
lamp will need to be removed attached to it's mounting bracket
and then removed from the bracket before the bulb can be
replaced.
For access to the bulb, remove the two securing screws and lift
away the lens.
Remove cover by squeezing the sides together and lowering
away from light unit. Turn tube through 90º to release from end
holders.
Access to the bulb is via removing the four end cover screws and
lifting away the lens.
34
