GENERAL MAINTENANCE
ELECTRONIC CHECK
Simultaneously press the UP and DOWN arrow keys to enter the oil
level display mode.
A two minute countdown begins after the following conditions are
met:
* Engine is at idle.
* Sump oil is at operating temperature.
* Transmission output shaft is stopped.
* Transmission is in neutral.
* Oil level sensor is functioning properly.
Failure to meet any of the above conditions stops the two minute
countdown and the display shows the cause by means of a code:
Code
Meaning
OL,- -,50 Engine rpm too low.
OL,- -,59 Engine rpm too high.
OL,- -,65 Neutral not selected.
OL,- -,70 Sump oil temp too low.
OL,- -,79 Sump oil temp too high.
OL,- -,89 Output shaft rotating.
OL,- -,95 Oil level sensor failure.
The shift selector can only display one Character at a time.
The display flashes and a 8,7,....1 count occurs during the two
minute countdown. Oil level information displays after the
countdown.
After two minutes the shift selector displays the oil level data as in
the following examples:
OL,OK,OK - Oil level correct
OL,LO,01- Oil level one quart low_or as many quarts as needed.
OL,HI,01 - Oil level one quart high_or as many quarts as overfilled.
Exit the oil level display mode and return to neutral by pressing the
neutral selection button.
51
