Engl
is
h
11
GNSS Toolbox
GNSS Toolbox
is used to control and monitor important
functions in your receiver. These are listed and detailed
below.
•
GNSS Settings
: Constellations and frequencies used in the
receiver.
•
GNSS Status
: Views GNSS reception monitoring screens.
•
Reset
: Resets the receiver.
•
About
: Provides the software version of GNSS Toolbox.
GNSS Settings
•
Open the
GNSS Toolbox
and tap on
GNSS Settings
. This
opens a new window where you can make the following
settings:
–
Tracking mode
: Only the “GPS L1” option is available,
which means the receiver can only operate from the L1
signal of the GPS constellation.
–
Use SBAS
check box: Check this box to enable SBAS
reception, clear it otherwise.
–
Elevation mask
: Any satellite seen from the receiver with
an elevation angle less than the specified elevation
mask will be rejected. “5 degrees” is the default and
recommended value for this parameter.
•
Tap
OK
to confirm your choices and return to the GNSS
Toolbox window.
GNSS Status
•
Open the
GNSS Toolbox
and tap on
GNSS Status
.