1408201627 Rev G
05 August 2015
BATTERY REPLACEMENT INFORMATION
Battery models only
When the batteries weaken, the red indicator light will blink at a
constant rate when the user’s hands are within the sensor range. The
batteries must be replaced within two weeks.
To replace the batteries:
1. Carefully open the battery box, use Phillips drive #2 to remove cover
screws (Fig. 1&2, below)
2. Remove the old batteries from carrier tray (Fig. 3)
3. Replace the used batteries with new D batteries in same polarity
(Fig. 3)
DO NOT
use steel wool or cleansing agents containing alcohol, acid,
abrasives, or the like. Use of any cleaning or maintenance products
containing these substances could damage the surface of the soap
dispenser. For surface cleaning use ONLY soap and water, then wipe dry
with a clean cloth or towel. When cleaning bathroom tiles or counters,
protect the soap dispenser from any splattering of harsh cleansers.
Care and cleaning of chrome and special finishes- see also PCM document.
NOTE:
Do not mix used batteries with new ones.
4. Close the box and re-tighten the screws (Fig. 4) and reconnect battery cable.
1
2
3
4
Important: Spent batteries should not be discarded of with
normal household waste. Contact your local authority for
information on waste disposal and recycling.
MAINTENANCE
10
