1408201654 Rev C
27 July 2015
OPERATION
1- SOAP VOLUME
3- TEMPORARY OFF FUNCTIONS
4- STARTING SOAP LINE AFTER REFILLING
SOAP TANK
2- ADJ
If desired, use the remote control to adjust the soap dispenser settings. Hold the
remote control straight in front of the sensor at a distance of about 4-6” (10-15cm).
User Hint: Holding the soap dispenser remote control out of the recommended range (too
close or too far) may interfere with the remote’s activation.
Confirmation: continuous blink of the red light in the sensor eye.
*The exact soap dispense volume depends on the soap viscosity. Factory setting is 0.03 oz (0.8 ml).
This function allows reverting to soap dispense volume
factory setting.
Confirmation: 2 blinks of the red light in the sensor eye.
This function is ideal to perform any kind of activity in front
of the sensor without operating the system (for example,
cleaning). The soap dispenser will remain off for one (1)
minute when this button is pressed once.
To cancel this function and to return to normal operation
press the On/Off button again or wait one (1) minute.
Confirmation: OFF – 2 fast blinks, ON – 4 fast blinks
Once the soap tank has been filled \ re-filled, press
the FILL button. The pump will run for one (1) minute
to allow the soap to start coming out of the soap
dispenser spout.
To stop this activity press the FILL button again. If the
soap has not started coming out of the spout, check
for leaks and / or kinked or blocked or disconnected
tubing. If all ok, then press the FILL button again.
Repeat as necessary.
Choose the function you want to adjust by pressing on the function button as follows:*
The 1-4 drop keys allow the owner to control the desired soap dispense volume.
.004 to .013 oz
(0.2 to 0.4 ml)
1
2
3
4
.023 to .030 oz
(0.7 to 0.9 ml)
.041 to .054 oz
(1.2 to 1.6 ml)
.071 to .078 oz
(2.1 to 2.3 ml)
14
3
1
2
4
