1408201627 Rev G
05 August 2015
7
INSTALLATION
Connect the Com Cable motor connector to the mating plug
from dispenser (If not already connected in Step 3 above).
Please note that since the connector is water proof, some
friction will apply.
Important:
the 4 contacts connector should be inserted fully so
that the white
O
-ring is not visible and a clicking sound is heard.
NOTICE:
If the 4 contacts connectors are not connected properly,
the motor will run continuously.
Remove the protective sticker
covering the sensor. Keep away
from the sensor range.
O
-RING VISIBLE –
IMPROPERLY CONNECTED
ONLY THE GROOVES ARE VISIBLE -
CONNECTED PROPERLY
5
CONNECTING THE POWER SOURCE
6
