ASI Dental Specialties
6 – CLEANING/DISINFECTING, STORAGE & SHIPPING
www.asisupport.com
Page 4
65-0060 Rev-B (04/27/21)
3
With a waste basin located below the filter assembly, unscrew the bowl that houses the filter. Let the
remaining waste drain from the tubing and housing completely.
4
Remove the old filter and discard. Replace the filter screen by placing in the bowl assembly, then
re-tighten the bowl assembly to the in-line filter.
Depressurizing and Removing Moisture Condensation from Air Tanks
Compressing air creates moisture condensation which will store in the air tanks and will build up unless purged.
To purge the air and moisture condensation from the system, locate the toggle switch on the right side of the
back door. Open the valve to allow air and moisture to escape. Use a small cup under the port to capture any
moisture. Let the air exhaust out until moisture ceases and then shut the valve securely to prevent loss of air to
the handpieces.
Exterior Cleaning and Worktop
The exterior of the delivery unit should be thoroughly cleaned and disinfected after use each day to maintain
optimal performance. All components should be maintained in proper working order and replaced as required.
Worktops and Control Panel Overlays
The worktop is either an engineered quartz top or a solid surface polymer top. The overlays are plastic with
transparent windows. Do not use abrasive pads on these surfaces as it will scratch and damage them. Only use
soft cloth or sponge with mild detergent type solutions that can disinfect.
Follow the guidelines listed below to keep your composite solid surface worktop looking as good as new.
•
Most dirt and stains - use soapy water or ammonia-based cleaner
•
Water marks - wipe with damp cloth; towel dry
•
Disinfecting - occasionally wipe surfaces with diluted household bleach (1 part water/1 part bleach)
Painted Work Surfaces and Handpiece Holders
Do not spray detergents or solutions directly into openings on the cart or the ball valve of the holder, as this may
damage internal components. If you are using a spray solution, please spray onto a soft cloth or sponge before
wiping down these surfaces.
