AMERICAN SPECIALTIES, INC.
441 Saw Mill River Road, Yonkers, NY 10701
(914) 476.9000 • (914) 476.0688
www.americanspecialties.com
MODEL №:
ISSUED:
REVISED:
THIS MANUFACTURER RESERVES THE RIGHT TO MAKE CHANGES IN DESIGN OR DIMENSIONS WITHOUT FORMAL NOTICE
IMPORTANT: READ THESE INSTRUCTIONS COMPLETELY PRIOR TO BEGINNING
INSTALLATION & RETAIN FOR FUTURE REFERENCE WITH SUB-SYSTEM OM’S.
Open the mirrored door using the tumbler lock located at the bottom of unit in order to access the interior of the
module. Use caution when opening the door as the gas springs will raise the door from closed position. Remove
and retain the key for future access.
Pack contents:
1x 12V AC/DC Adapter with 1 output plug for Foam Soap Dispenser
1x 12V AC/DC Adapter with 2 output plugs for EL Lighting System
2x Mounting Hanging Brackets
INSTALLATION OF WALL MOUNTING HANGER HOOKS
Appropriate wall reinforcement and AC quad outlet must be prepared prior to initiating the Velare™ BTM
System installation (see Fig. 2 for blocking reference and Fig. 5 for Electrical KO location). Install the two (2)
wall mounting hanger hooks located in the interior of the module on wall using twelve (12) № 12 self-threading,
pan-head screws (by others) (Fig. 1) into appropriate wall reinforcements (Fig. 2). Hang the cabinet on wall
mounting hanger hooks (Fig. 3). Suggested mounting height is to position bottom of module 16" [406] to
20" [508] above vanity top (Fig. 4). Power can be provided to the interior of module through the Electrical
Service KO for Quad Outlets located at the back of the cabinet.
IMPORTANT:
Install two (2) № 12 self-taping locking screws (by others) at the security locking holes to
prevent unit from being lifted off hanger hooks.
0663-T
29 JAN 2019
13 MAR 2019
VELARE™ BTM SYSTEM CABINET INSTALLATION GUIDE (PAGE 1 OF 3)
FIG. 1
FIG. 2
NOTES:
Dim's inch [mm] & NTS
See TDS for Dim's not shown
