stops. Use only suitable saw blades.
Release the quick-release chuck. The chuck must
return to its original position.
Check that the saw blade is fi xed correctly.
If you turn the handle, we insert the saw blades
rotated 180 °.
Disassembly of the saw blade
do the opposite of inserting the saw blade
Starting and stopping (E)
To start the saw, press the switch (2). To switch off the
saw, release the switch (2).
Switch the saw to continuous operation by pressing
and holding the switch (2), at the same time pressing
the locking button (5). Then release the switch (2).
To switch off continuous operation, press the switch
(2) again.
Rotating the handle (C)
The handle (9) can be turned 90 ° to the left or
transport.
1. Press the release button (8) and turn it
handle (9) clockwise or counterclockwise.
2. The handle (5) should lock in place.
Adjusting the guide support plate (D)
You can adjust the length of the guide foot.
Please note that the support plate can only be safely
secured to a certain point.
Check that the guide support foot is fi rmly seated.
Vibration frequency setting (K)
You can use the control (5) to select the desired saw
blade oscillation frequency.
1-2 = Low oscillation frequency,
3-4 = Mean frequency of oscillations,
5-6 = High oscillation frequency
The vibration frequency must be set depending on
the type of material and the working conditions. The
frequency must be high enough for the work to make
reasonable progress, but at the same time low enou-
gh to maintain a clean cut and to prevent deformation
of the material being cut. In general, fi ner saw blades
work at a higher frequency of oscillations, coarser
blades bring.
After prolonged work at a low oscillation frequen-
cy, cool the saw by letting it run without load at a
maximum oscillation frequency of approximately 3
minutes.
CUTTING TIPS
Set the saw blade to the speed according to the
material you are going to machine. For rectangular
cuts, we recommend that you use a thin saw blade.
Use coolant to prevent the saw blade from cracking
along the cutting path.
Before cutting, check wood, chipboard, building mate-
rials, or for unwanted objects (wedges, screws, etc.).
If necessary, remove them.
Fasten the material correctly. Never support the
workpiece with your hands or feet. Never touch the
material to be cut while the saw is in operation.
It is not allowed to cut materials that contain as-
42
Summary of Contents for AE5PO85
Page 4: ...4 ...
Page 71: ...www rs we com ...
