9.8. Mechanical stage K 150 and K 200
sed for the systematic scrutinizing of large ob-
dard incident light stand can’t be used
adapt the K 150 or K 200.
.8.1. You have to follow the instructions
elow to
assemble the K 150 and K 200
on
be disconnected from the power supply and
mechanical stage K 150 or
200 will fixed with two screws on the base
the base of transmitted and inci-
ent light the assembly has to be in the same
.8.2. For a fast and coarse alignment of
bjects a handhold (1) can be found on the
The Mechanical stages K 150 and K 200 are
u
jects up to 150 mm or 200 mm edge length.
The Mechanical stage K 200 is to be used
solely for incident light investigations and can
be used only with a special incident light
base.
The stan
to
9
b
the base for transmitted and incident light (T/I):
The base for transmitted and incident light has
to
the column has to dismounted. The column will
mounted on the mike boom. Now the mike
boom has to be mounted with 3 screws on the
mechanical stage (the glass plate has to be
removed before).
The pre-assembled
K
for transmitted and incident light. The glass
plate can be inserted again and the clamp
ring and the microscope can be assembled at
the column.
At usage of
d
wise.
8
o
right site of the stage. The mechanical stage
can be adjusted sensitive in x –y direction with
the help of the coaxial stage drive (2). Objects
can be looked line by line by using the clamp-
ing (3) without changing the y- direction.
Picture 42: Mechanical stage K 150
31