Placing the dishwasher
The dishwasher can be installed built-in, completely freestanding or
partially built-in.
A. Built-in
The dishwasher is intended for installation under a worktop. The recess
dimensions are illustrated. Holes for wires/cables need not be larger
than 38 mm in diameter. Make sure the edges of such holes are even
to prevent damage to the drainage and inlet hoses and the power ca-
ble.
Ø. 38
600
50
131
860-915 860-915
>
560
[mm]
B. Freestanding
A freestanding dishwasher must be fitted with anti-tip brackets. This
comprises two brackets, which are screwed into place as illustrated.
The dishwasher is then pushed in so that the brackets engage the rear
feet. Now the dishwasher will not topple if pressure is put on the open
door. If the dishwasher is installed completely on its own, side panels
and a worktop must both be fitted. Accessories can be purchased
where you bought the dishwasher.
413
WARNING!
A completely freestanding dishwasher must be fitted with anti-tip
brackets.
C. Partially built-in
If the dishwasher is located so that one of its sides is visible, a side
panel must be fitted. Accessories can be purchased where you bought
the dishwasher.
Affix the protective film
Attach the protective film (packed in the document bag) to the under-
side of the worktop. The protective film is to protect the worktop from
moisture.
NOTE!
The surface to which the protective film is affixed must be clean and
dry.
21
Summary of Contents for DBI654IBXXL
Page 1: ...Dishwasher DBI654IBXXL OPERATING INSTRUCTIONS ...
Page 26: ...Your notes 26 ...
Page 27: ...Your notes 27 ...