12
ERROR MESSAGES
If an error occurs during the program a message is shown
on the display. To exit the message after taking measures,
turn the machine o
ff
and then back on.
The error messages that may be shown in the display are:
Close the Door
Close the washing machine door and press Start to start
the programme.
Over
fl
ow fault
1 Shut
o
ff
the water tap.
2 See
“Drainage
error”.
Water outlet fault
Check:
• that no objects are stuck in the drainage hose outlet.
• that the drainage pump is not blocked by foreign
objects. Clean the pump. See the “Care and cleaning”
chapter.
• that there are no kinks in the drainage hose.
Press the Stop button to empty the machine of water
before opening the washing machine door. If this does not
resolve the problem, call the service division.
Water inlet fault
Check:
• that the tap on the water pipe is open.
• that
the
fi
lter in the machine’s water inlet is not blocked.
Action:
1 Shut
o
ff
the water tap and unscrew the hose.
2 Clean
the
fi
lter in the inlet valve on the machine.
3
Screw the hose back on and turn on the tap.
4
Run the program again to check if the fault is
fi
xed.
5
If this does not resolve the problem, call the service
division.
Wash motor fault
Call the service division!
Unbalance
The machine stops the spin cycle if there is too much
imbalance. The washing machine restarts the spin cycle
and hopefully the washing is better distributed in the
drum. This procedure can be repeated up to 10 times.
If the machine still fails to
fi
nd a good balance, the
programme jumps to the next step.
The error message requires no action.
TROUBLESHOOTING
